163cm Head 45 and 39 Review

xcentrik · Post by **xcentrik** » Mon Aug 17, 2015 12:52 am

and the navel pierced

thelionking · Post by **thelionking** » Mon Aug 17, 2015 5:24 am

Looks like WM updated their vaginal/anal placement? Looks like all they did was move the anus down (if she is in a missionary position) more. So, the vagina still looks incorrect with the anus in the correct place. If they moved the vagina down more as well it would be correct. Just my observation IMO. I could be wrong though.

xcentrik · Post by **xcentrik** » Mon Aug 17, 2015 10:27 am

it takes some experimenting. In missionary, if you want to play with her she either needs to have her legs spread out to the sides 180 degrees like if shes doing a split or if i want to lift her legs up i have to carry her and support the back of her torso on a desk. This is because of the position of her girly parts and you trying to go in all the way. Thats just my case but it may vary for you with how you are shaped and length. You can do missionary if you lay on top of her but my two suggestions allow me to look at her at the same time because im angled slightly away from her torso.
Regarding inserts, you can use other inserts like the lilith but the opening is so tight and creates so much suction that somehow i end up using tons of lube. This doesnt happen when i use the same inserts on an inflatable. I ended up getting some aloe vera gel because its cheaper. It was like $6 at Walgreens for 16oz and it comes in a hand lotion dispenser bottle. I havent tried the home made recipe for making water based lube with xhanthan gum and glycerin.
The other orifices are fine but are more difficult to clean and the oral you might want to take the head off. If you try to do oral while sliding on her breasts you put too much stress on her neck. These dolls have an issue where if you tighten the head all the way the neck's flexible tube compresses and with the tension you might end up breaking the neck if you try to move it around because you are over extending it.
If shes in doggie position on the bed and im standing on the floor i have to position her back arched down instead of arched up as expected. it may be because the height of the bed. i had to buy a platform metal bed frame which is 14 inches high underneath to give me space to slide her box under the bed. it was like $100 on ebay for a queen size mattress

xcentrik · Post by **xcentrik** » Mon Aug 17, 2015 11:45 am

The box is 10x17x62 inches(25x43x157cm). You can also use a padded bag of snow skis to store her. Like a 156cm

guitarpussy · Post by **guitarpussy** » Mon Aug 17, 2015 1:10 pm

xcentrik,

Very nice choices in her outfits and makeup.

As for hanging her up for storage and/or play, does she have a the means to screw an eye-bolt into her back or do you have something to screw onto her neck ? Or do you just only use that swing for her to sit in and hang it from the pullup bar ? I ask because I think I read awhile back that the neck wasn't meant to hold the weight of the bigger dolls. Also I think the factories were making an optional hole in the back that would allow applying a threaded eye-bolt, like in an Abyss RealDoll.

Thanks, GP

xcentrik · Post by **xcentrik** » Mon Aug 17, 2015 3:06 pm

There is a "birthmark" between her shoulder blades. Thats the spot where you can screw an eye hook on the spine.
Note that this doll is not designed to be stored hanging.
TPE is like an extremely heavy chewed gum. Silicone dolls are different because the material is not that soft so there no risk of deformation like with the TPE. You may hang it for a couple of minutes but over long periods, the material is so heavy that either
a) the screw will break inside the spine and the doll will fall
b) the doll will deform due to the weight
c) some really cool disaster ( make sure you film it and upload it to youtube )

So with this knowledge most likely i will hang her to take some quick photos but thats it

xcentrik · Post by **xcentrik** » Mon Aug 17, 2015 6:27 pm

What i meant by birthmark is a discoloration due to filling the hole after manufacturing

xcentrik · Post by **xcentrik** » Mon Aug 17, 2015 8:24 pm

Ok so I finally decided a name. #45 is Maya and #39 is amanda
Here is their back view angle

PlasticArtist · Post by **PlasticArtist** » Mon Aug 17, 2015 9:54 pm

I think the boobs have been improved.
Nice doll.

xcentrik · Post by **xcentrik** » Tue Aug 18, 2015 12:11 am

guitarpussy wrote:xcentrik,

Very nice choices in her outfits and makeup.

As for hanging her up for storage and/or play, does she have a the means to screw an eye-bolt into her back or do you have something to screw onto her neck ? Or do you just only use that swing for her to sit in and hang it from the pullup bar ? I ask because I think I read awhile back that the neck wasn't meant to hold the weight of the bigger dolls. Also I think the factories were making an optional hole in the back that would allow applying a threaded eye-bolt, like in an Abyss RealDoll.

Thanks, GP

Thanks. Regarding the swing, i only meant it as a way to hold her weight. for example,
if the doll is on top, you would have to carry her 70.4lbs (32kg) with your hands up and down because she has nowhere to support her weight. she cannot use her legs to support the weight on the bed. on a chair is no fun either. the swing holds her legs so all you have to do is swing her instead of lifting her.

xcentrik · Post by **xcentrik** » Tue Aug 18, 2015 1:14 am

ok so doing some research i found this. this should hold her weight.
interesting... should i get one? ummmm...
if u dont fit inside (21 x 2 x 7 inches) then dont even consider it!
Heres the amazon link:
http://www.amazon.com/gp/product/B001MY ... g=nek04-20

xcentrik · Post by **xcentrik** » Tue Aug 18, 2015 3:23 am

The rest of Amanda's juicy shorts

Mark Hunt · Post by **Mark Hunt** » Tue Aug 18, 2015 3:46 am

Thanks for these reviews ! I'm new here and I'm interested in purchasing a love doll. As I understand there are two type of material : TPE and Silicone. According to the pictures I have seen on the forum, TPE seems to be more realistic with tanned skin or is it just my impression ?

xcentrik · Post by **xcentrik** » Tue Aug 18, 2015 4:04 am

Maya taking a selfie

xcentrik · Post by **xcentrik** » Tue Aug 18, 2015 5:53 am

It turns out that the easiest position to do missionary is also the easiest way to pull out and put in the insert:
her legs need to be spread apart completely. any other leg position squeezes the insert ( and you too )