Teeth&Tongue set version 4.0 is out!

The Doll Laboratory · Post by **The Doll Laboratory** » Mon Feb 13, 2023 4:35 am

Hello Cayim,

Cayim wrote: ↑Sun Feb 12, 2023 7:48 amI haven't removed any material from my 398

Thanks for the info. That's good to hear...

Cayim wrote: ↑Sun Feb 12, 2023 7:48 amI have a few heads, and the braces definitely work the best with her, but I would probably have to remove material for a good look with a few of my other heads, like #124 (tpe teeth as part of their normal lips).

The T&T set works better on some heads yes. But if the heads already have TPE teeth then these will have to be removed for a better appearance.

Cayim wrote: ↑Sun Feb 12, 2023 7:48 amAnd sure, I don't mind if you use the photos to show how the braces look.

Cayim wrote: ↑Sun Feb 12, 2023 7:48 amI recently got asked where I got them I another thread, so figured I'd toss a few pics in this thread to reference. I've got a few more photos of using the inserts, if you'd like me to post them here too.

Yes please do. You can post any photo of your Doll with the T&T set in this thread. The more the better...

Cayim wrote: ↑Sun Feb 12, 2023 7:48 amAlso, once I get my replacement doll and can take new photos, I could snap up a few more, if you wanted before/after photos or something.

Yes, no problem, please go ahead! Thank you!

!!! - - - - - - - - - - !!!

I have a message for member bbgng8: I can't contact you via Private Message because it seems you have disabled private message receipt. At least that's what the TDF interface says when I try to reply to your PM.

Either you can enable private message on TDF or you can send me an inquiry mail to the following address: contact@thedolllaboratory.com

The Doll Laboratory

Cayim · Post by **Cayim** » Mon Feb 13, 2023 3:01 pm

Here are a few more I had taken, for comparison.

RootTheRoot · Post by **RootTheRoot** » Mon Feb 13, 2023 6:02 pm

Holy crap! Those are awesome!

Cayim · Post by **Cayim** » Tue Feb 14, 2023 3:07 pm

I don't have many of them in my #200 head, but here the few that I took (forgive the faded lipstick), and a few with just the tongues being used.

The Doll Laboratory · Post by **The Doll Laboratory** » Wed Feb 15, 2023 4:14 am

Hello,

RootTheRoot wrote: ↑Mon Feb 13, 2023 6:02 pm Holy crap! Those are awesome!

I am glad you like them!

Cayim wrote: ↑Tue Feb 14, 2023 3:07 pmI don't have many of them in my #200 head, but here the few that I took (forgive the faded lipstick), and a few with just the tongues being used.

Thank you for the additional images Cayim! The T&T works quite well on head #200 indeed...

Cayim · Post by **Cayim** » Tue Feb 28, 2023 11:02 am

Is there a post with more info about your movable eye system? Does it work with the default WM eyes?

The Doll Laboratory · Post by **The Doll Laboratory** » Wed Mar 01, 2023 2:41 am

Hello Cayim,

Cayim wrote: ↑Tue Feb 28, 2023 11:02 amIs there a post with more info about your movable eye system?

I spoke about it in my various threads I suppose but I don't think I have created a specific post for it. Should I?

Cayim wrote: ↑Tue Feb 28, 2023 11:02 amDoes it work with the default WM eyes?

Yes. I have two types of adapters for the two type of WM eyes.

The Doll Laboratory

Cayim · Post by **Cayim** » Wed Mar 01, 2023 8:09 am

The Doll Laboratory wrote: ↑Wed Mar 01, 2023 2:41 am Hello Cayim,

Cayim wrote: ↑Tue Feb 28, 2023 11:02 amIs there a post with more info about your movable eye system?
I spoke about it in my various threads I suppose but I don't think I have created a specific post for it. Should I?

Cayim wrote: ↑Tue Feb 28, 2023 11:02 amDoes it work with the default WM eyes?
Yes. I have two types of adapters for the two type of WM eyes.

The Doll Laboratory

I wouldn't mind a post about them. I'm currently using a different set of eyes for some of my heads (Easy Move Eyes, by MF Creations) which are handy for swapping eye colours quickly, but I still have a bunch of the "normal" WM eyes, and it would be awesome to have better options than cotton for those.

How much do you typically sell them for?
Thanks!

Star88 · Post by **Star88** » Wed Mar 01, 2023 12:36 pm

Want to drop in here and share a quick mention about my recent additions courtesy of The Doll Laboratory.
1st of all, 100% FANTASTIC vendor!!! Encountered a tiny issue with my order, I emailed only to mention it as it (wasn't a big deal to me) and the order was corrected and replaced without delay or hesitation. That's the kind of customer service all businesses should try to emulate.
2nd, I knew these were going to be great accessories from what I'd seen here, but they really exceeded my expectations.
I have little doubt that I'll be looking into more once I've had time to experiment and photograph with these.

Here are 2 quick snaps with the "gap" teeth just to start

: tt1.jpg (403.5 KiB) Viewed 698 times

: tt2.jpg (487.56 KiB) Viewed 698 times

Thank You Doll Laboratory

The Doll Laboratory · Post by **The Doll Laboratory** » Sat Mar 04, 2023 5:14 am

Hello Cayim,

Cayim wrote: ↑Wed Mar 01, 2023 8:09 amI wouldn't mind a post about them.

Will do one when I have the time...

Cayim wrote: ↑Wed Mar 01, 2023 8:09 amI still have a bunch of the "normal" WM eyes, and it would be awesome to have better options than cotton for those.

I understand. Cotton behind the eyes is a pain. My System is much more practical and you can adjust the depth of the eyes with it.

I know that Mandos/Cubiko uses it a lot.

Cayim wrote: ↑Wed Mar 01, 2023 8:09 amHow much do you typically sell them for?

Only the Movable Eyes System with adapters for WM eyes? I sell them for 25€ one pair with Shipping and PayPal fees included.

The Doll Laboratory

The Doll Laboratory · Post by **The Doll Laboratory** » Sat Mar 04, 2023 5:24 am

Hello Star88,

Star88 wrote: ↑Wed Mar 01, 2023 12:36 pmWant to drop in here and share a quick mention about my recent additions courtesy of The Doll Laboratory.
1st of all, 100% FANTASTIC vendor!!!

Thank you Star88!

Star88 wrote: ↑Wed Mar 01, 2023 12:36 pmEncountered a tiny issue with my order, I emailed only to mention it as it (wasn't a big deal to me) and the order was corrected and replaced without delay or hesitation. That's the kind of customer service all businesses should try to emulate.

It was really the first time I put the wrong version of the T&T set in a customer's package. Again I am sorry for that.
But my mistake my bad, in the end you got one T&T set for free...

I see you used the “wrong“ gap teeth for your photos. They look good. I always found that gap teeth make girls look a little more “dirtier“ than the norm...

Star88 wrote: ↑Wed Mar 01, 2023 12:36 pm2nd, I knew these were going to be great accessories from what I'd seen here, but they really exceeded my expectations.
I have little doubt that I'll be looking into more once I've had time to experiment and photograph with these.

The Doll Laboratory

Cayim · Post by **Cayim** » Wed Mar 22, 2023 6:10 pm

I got my new WM 172B, and will hopefully be able to grab some more shots of the teeth in action, but for now, here are a few quick ones I took, in head #400. I quickly popped them in, and they seem to fit her pretty well, with minimal adjustments.

Cayim · Post by **Cayim** » Wed Mar 22, 2023 6:13 pm

And some Standards, with tongues (and vampire to boot)...

Cayim · Post by **Cayim** » Wed Mar 22, 2023 7:49 pm

And since it came with a free extra head, here are are few quick ones with WM head #419. This head has a much steeper oral cavity, and more hard material as part of the lower part of the head/jaw (similar to 124), so I'm finding the inserts tend to push up the upper lips more, and are are harder to find a good position I think looks "right" (personal opinion, compared to how they fit for #400 or #398).