That horrible BJ face GONE

Strider · Post by **Strider** » Tue Jul 17, 2018 4:45 pm

Thank you, sir.

david 68 · Post by **david 68** » Tue Jul 17, 2018 5:16 pm

well i got work to do.... great fix !

Jarubar · Post by **Jarubar** » Thu May 02, 2019 11:04 am

How long do you think the pipe should be? Should it be close to flush with the entrance to the hole (like the pictures?) or longer? I read somewhere you said its best to keep the ppe as close to the tpe mouth a possibel to stop the eye bulge...

Maddas wrote:So here we go. Finished the mod with great success.
Tested and fully working without any face distortion.

I originally did this to gain extra penetration when using her but much to my surprise it stopped the horrible face distortion and eyes popping out.
Attached are pictures.

1st. Remove the face(it's pretty easy)
2nd. Grab a circular hole drill bit and drill out the backing of the throat (I suggest wearing a face mask to avoid breathing in the fibers)
3rd. Drill a couple of holes at the back of the skull to allow air flow(this is to allow air to escape when penetrating
4. Attach some pvc piping and glue it inside the skull(this is to help keep the tightness around your little/big 1)
5 Re attach the face and away you go

On a side note. I also modded the inner mouth to accept my downstairs by cutting the end off and attaching a larger masturbation sleeve and glueing it in.

Now you can go nuts without worrying or catching a glimpse of that horrible face we all know about when you go too fast and deep.

Iv done this to both my WM 156cm and JY 170cm.

Now go out there and go balls deep. Lol

Strider · Post by **Strider** » Thu May 09, 2019 1:10 pm

Jaubar, I did this mod on one doll. I made the pipe flush with the inside edge of the oral cavity on the skull. the "edge" is pretty rounded on my doll's skull.

Post by **setevoltas** » Thu May 09, 2019 10:14 pm

Possibly very stupid question. Is the PVC necessary?

Dollyman25442 · Post by **Dollyman25442** » Thu May 09, 2019 10:36 pm

See this thread
viewtopic.php?f=6&t=91728
Particularily page 10

Wheezer · Post by **Wheezer** » Fri Mar 06, 2020 1:49 am

Just a followup question, since this is an older post. How did it hold up long term?

I am wondering since I am getting a new head soon and I plan on doing your modification to it.
Pics of the head at the factory below

Maddas · Post by **Maddas** » Sat Apr 04, 2020 7:14 am

Sorry for the late reply as I have not been active for some time now.
The mod is holding up nicely, much better than the doll herself may I add.
I have recently snapped the stainless pipe in her hip so looks like she will be going in the bin, hahaha.
But as for the mod. Couldn't be any happier. Although. I plan on doing another mod slightly different and more refined in the near future with a new doll.