Sanhui 168 doll with new ball joint skeleton

Post by **dolls-castle** » Fri Apr 13, 2018 10:56 pm

Hi, sanhui doll lovers
This is a 168 doll with a new skeleton design, the skeleton is smooth and has a wide range move to more positions.
Please see the video..

DC team

kabuki · Post by **kabuki** » Sat Apr 14, 2018 1:22 am

Very interested to see what this looks like on the inside. I wonder if this reduces the wear on the silicone over time, compared to hinges.

Aeron · Post by **Aeron** » Sun Apr 15, 2018 6:48 pm

The video only shows one axis of rotation at a time. To demonstrate the ball-joint skeleton, is there a video showing the motion in 2 axes of rotation at once? So instead of up and to the side in two steps, it would done in one diagonal motion.

Post by **dolls-castle** » Sun Apr 15, 2018 10:01 pm

Aeron wrote:The video only shows one axis of rotation at a time. To demonstrate the ball-joint skeleton, is there a video showing the motion in 2 axes of rotation at once? So instead of up and to the side in two steps, it would done in one diagonal motion.

Ok, I understand. A new order of 168 is in process, I will do a video showing the motion in 2 axes after the doll has been done.

Thanks!

Miracle

Post by **dolls-castle** » Sun Apr 15, 2018 10:05 pm

kabuki wrote:Very interested to see what this looks like on the inside. I wonder if this reduces the wear on the silicone over time, compared to hinges.

I can not show you what this looks on the inside, cos I have no photo in hand. I will check it out.

Thanks.

Miracle