The Doll Forum

Hi,

I'm new, I just bought my first doll but I went for a 135cm one because it was cheaper (didn't want to spend too much if I wasn't happy)

The holes are far to tight, any suggestions on how to stretch / open them up? Doll is TPE.

Thank you

didn't u receive a heater with the doll? it may can help you.

You can lubricate a dildo with rubbing alcohol and work it in there, just select one slightly smaller than yourself. Leave it in for a few days and your problem will be solved.

Is there an alternative for the alcohol method?

If she's a virgin, she is SUPPOSED to be tight. So ya gotta break her in!
But in all seriousness, I don't know if there is much that you can do to open the holes due to the stretchy nature of TPE. So no matter how much you stretch her out, she is going to revert back to the pre-stretched state.
Although if she was warmed up and lots of lube is used, then that could help a little.
Is she a fixed vag design or does she use an insert? If an insert, then the insert could be trimmed out. While that COULD be done a fixed vag doll, I would be afraid to try it. At least inserts are less expensive to replace than a whole doll if something goes wrong.

amytyl wrote:You can lubricate a dildo with rubbing alcohol and work it in there, just select one slightly smaller than yourself. Leave it in for a few days and your problem will be solved.

The more I think about it, this could work as well. But I wouldn't try it more than a time or two as alcohol can weaken TPE.