Thndrrbolt wrote:ORdoll wrote:staycool64 wrote:Alex Please.... Show her Breast exposed with air injection and that is amazing that you injected a couple days ago and she still looks like her boob job is well Amazing. I still think your doll is going to be better shaped than well IDK if I can say this on your thread but will put it this way wm and OR have a new doll and still waiting to see ydolls new doll. Alexknight showed a picture of your doll in the shipping box and the breast look amazing and the butt is off the chart. Also Alex77 is the breast on Alexknights post with doll in box is the breast injected in that photo. It would be supper nice of you if you could show 2 pictures one with injection one with out so all of us can see for ourselves. PLEASE....... By the way the shipping box upgrade is a reallllyyy good thing. I do not think any manufacture can make an ass like your doll so the breast remain the only thing holding me back from me purchasing. Need to see first the boob job and one with out the boob job.
The hollow breast has only 1/3 of space is hollow. The air needed is very small amount. Without air, the breast hand feels just a little bit soft. You can not tell the different from your eye(no change of the breast shape). The first picture is hollow breast with air injected. The second picture is solid breast. Hope those picture answer your question.
Joyce
The attachment Hollow.jpg is no longer available
The attachment Solid.jpg is no longer available
[/quote
Joyce,
Thanks for mentioning that the hollow breasts are only 1/3 hollow. That gives some assurance that they aren't just "balloons"!
As for the air injection: are you using a standard hypodermic syringe and needle and injecting the air directly into the nipple?
If so, is it the nature of the TPE material that it seals the hole preventing rapid leakage?
I wonder if someone injected air and found that they would like the increased size and feel to be permanent, could they apply a small amount of TPE repair adhesive to the injection point, and would the breast then retain the air without leakage?
Thanks!
T'Bolt
T'Bolt,
You got the point! This is the syringe I used
- 235px-Syringe2.jpg (3.85 KiB) Viewed 3250 times
You may inject to anywhere you like. What I did was injected from side of 145:
1. Push in plunger of syringe once needle poke into breast from side.
2. Detach syringe from needle while needle still in place
3. Temporary seal end of needle with finger
4. Pull out plunger to fill in air of syringe
5. Attached to needle to push in more air
6. Repeat process to desire size and hardness of breast.
7. pull out needle slightly, apply small drop of TPE glue to needle
8. Push in needle to glue and pull out fast. It will seal immediately
It's been about a week after injection and so far so good.
Surprisingly, although I had over injected with air (she looks bigger than my 156), her breast is as soft.