Forum Rules,TOS and Privacy Policy | By visiting this website and viewing the pages within, you accept and agree to be bound by and comply with our Rules Of Conduct, Terms Of Use and Privacy Policy
So, I recieved my first ever sexdoll. A 3'3" big boobed blond. 339 dollars but honestly, I think she is a knock off.
Be that as it may, when I went to install her head there were two bolts. One bolt was all thread nearly the entire length. The other bolt was threaded at one end but the other end had several balled key ways in it. Well, I tried and tried and couldn't figure for the life of me how the two would install together. So, I just put her head on using the all thread bolt. But, it only turns left or right and doesn't tilt up or down. Can anyone enlighten me? Did the wrong parts get packaged with the doll? Is something missing? Or am I dummer than I thought.
Thanks
You don't install them both. Pick one: screw on, or clip on. The screw on ones are more stable during fun time because having her head pop off in the middle can be somewhat off putting.
If you're taking her head on and off a lot then use the other one. It's much quicker and easier to pop her head off than to unscrew it. Screw the screw bit into the head, and the other end goes in the neck.
Neither will tilt at the bolt; this is normal. You angle her head at the neck joint. A tilting head bolt is a fairly recent invention though, so these might get more common.
Why don't they just have a pivot bolt permanently in the head. Then all one need do is screw it into the neck. Now it's secure, tilts up and down, and turns left and right. The frictional resist in the tpe at head and neck joining would keep it from tilting too loosely.