S hook for Lifting ?

[st71]

anybody invent one of these yet?

[ generic picture manipulation for visual representation - pay no mind to coating or shaved edges ]

Something like this that would support the weight of a doll in both lifting and hanging.

Dimensions would need figured out to allow safe hanging with the hooks [not slip off or bend at the M16 ] and the hole would have to be large enough to allow a 12" or 18" piece of pipe, strong conduit, or hardwood dowel to pass through. The hook would also need to be large enough diameter to properly seat to a closet or storage rack bar.

Lifting would be done with hands on both sides of the pipe, with the device centered. [ remove pipe, conduit, dowel afterward ]

Purpose is to lift without having the full weight of the doll spread out over the surface area of just 2 hands where the squishy gets pressed against the skeleton....

Lifting becomes a more natural position of a weight lifting curl for those with upper body strength .. while those without can grab the pipe, lock shoulders and elbows and then raise the doll by lifting with their legs.

If this already exists and is available for purchase, leave a link.