S.O.S. Help me please. only 5 MINUTES for HELP

mrhans · Post by **mrhans** » Thu Jun 11, 2015 4:29 pm

I'm absolutely new in this, and I don't domain the english language.
I have one mannequin and I want to coustomize it.
How can I open the hole vagin? With a cutter?
Wich silicon vagine is more apropiate and how can I put it well at the pusy zone?
How can I paint the pezons of the tits? acrilic? nails paint?
Please....
Very very very thanks to you.
Mr. Hans.

rubherkitty · Post by **rubherkitty** » Thu Jun 11, 2015 4:45 pm

There are a numbers of ways to do this.
Please research the work of "mannequin fan" and myself among others in the "mannequins" and "inventors corner" sections for some ideas.

LovesBlackWomen · Post by **LovesBlackWomen** » Thu Jun 11, 2015 10:05 pm

Ask MannequinGirl4. He "modifies" mannequins.

narcissus · Post by **narcissus** » Sun Jun 28, 2015 1:24 pm

I used a Dremel tool to get into mine. The plastic ones you could use a box cutter, Xacto knife, just be careful. Best to use a Dremel, easier.

mannequin man · Post by **mannequin man** » Mon Jun 29, 2015 3:25 pm

using a standard 2" hole saw for installing a doorknob into a door works fine, as well the standard 2" hole will accept most fleshlites. you may have to smooth some silicone around the area, but not a hard task. what i do, is i take the 2" hole saw assembly apart, (remove the chuck with the drill bit ), then place the hole saw where you want it between her thighs, sharpie around that, then while holding it there, place the sharpie into the chuck hole, marking your drill point. this will insure you don't cut into the thighs as much as possible. assemble the chuck & saw, make yoour hole, then the scrap can easily remove with just disassembling the chuck / bit. then as well, follow with the others advice, & you should be fine.

MM