3d printable doll cleaning wand
3d printable doll cleaning wand
The "hose_adapter_od" parameter in Fusion 360 lets you control how large the end of the wand is to match your facet and for me, I found that a 22mm (7/8 inch) inner diameter silicone hose worked well. To make the hose adapter on the wand tight, I made its outer diameter slightly larger, 23mm. My 3d printer is really small so I separated the wand into 2 bodies that are glued together with epoxy. I printed the two parts in PLA and oriented them horizontally for the best strength. The glue joint adds a lot of strength as well and might be a good idea even for larger printers. A silicone hose, hose clamp, and zip tie complete the project. All the edges are rounded over in the model but I also use some sandpaper to make sure there are no rough edges. To insert the wand I cover it with foamed soap and pre-twist the hose counter-clockwise. Then as it's inserted, it's allowed to untwist itself in a clockwise direction to straighten out. I run the facet for a minute, then remove the wand and cover it with foamed soap, and repeat the process.
Re: 3d printable doll cleaning wand
Re: 3d printable doll cleaning wand
I like it, great job dparson
Check us out today! I guarantee you won't be disappointed
Website:
https://sxdolled.com/
https://sxdolled.com/collections/sex-dolls
E-mail:
info@sxdolled.com
Follow SxDolled On: Instagram | Twitter | Pinterest | Discord