Cheap, easy head stand

[Fallman68]

Been having extra heads sitting on the floor for a while now so I decided to come up with a solution to protect these rather expensive to replace heads I have.

1. Found some scrap MDF laying around the garage and cut it to 9x9 inches for the base and 3x3 inches for the m16 bolt holder.

2. Used 1 inch wood boring bit to drill hole in center of 3x3 piece of MDF.

3. Screwed 3x3 piece to center of 9x9 piece.

4. Added some epoxy to center hole, tapped in two and a quarter m16 bolt and covered smaller top piece with epoxy. Let dry for a few hrs and there you go!

[Photo_guy]

Oh yea! I like it.
"If the women don't find you handsome, they should at least find you handy!"

[Fallman68]

Thanks photo guy!