realsexdoll.com

Cayenne Cleur and Kimmi Lovecok side by side comparison

Palace of the plastic princess. Usually ranging from $15 to $300
User avatar
sam treadwell
Doll Advisor
Doll Advisor
Posts: 811
Joined: Fri Jun 24, 2011 1:59 pm
Location: Anaheim
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by sam treadwell »

yorktown wrote:8) Howdy

Before using sharp instruments - :!: on an inflata-babe

See if you can just gently rub the insert - starting at the edge and gently using the rubbing motion to pull off the insert - working around the entire insert -
Yes, that's good advice, and Capt Yorkie is right. I thought about it after I posted, and then realised that it probably wasn't the best advice, so I modified my words slightly. If I recall, I think that I just tugged at the insert gently until it finally came loose. I wasn't as lucky as many here, and the insert in my doll showed no signs of coming loose on its own.

Sam

User avatar
erf72
Apprentice
Apprentice
Posts: 19
Joined: Mon Sep 19, 2016 1:55 pm
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by erf72 »

sam treadwell wrote:
erf72 wrote:I agree the inserts do look good but if I want some extra fun with her I need to replace them as they are to small, I'm just a bit concerned I'll damage her pulling them out. Did you notice if there was glue around the top edge only or all the way down when yours came out?
Hi erf72. They are only glued at the top, not all the way down. You might have to use a razor knife and be real careful. I managed to remove the stock insert from my Agent 69 without damaging her. The problem with these particular dolls is that the insert is not designed to be removed because there is a vinyl lip that the insert glues to at the surface. As a result what happens is that this lip will split from continually removing and reinserting the insert, and can tear into the inner vinyl chamber if it goes too far. Ideally you would take a spare piece of vinyl and reinforce this area to prevent the tearing.

I know what you mean about how incredibly tight these dolls are. That being said, I was able to successfully use my Agent 69 in her stock configuration with a viagra hard on, plenty of lube, and a will to succeed :mrgreen: It really helps to deflate her down quite a bit first, since the more that she's aired up, the tighter she is.

Sam
I had all the will in the world but no viagra, guess that was the problem :) Anyway I think I'm going to have to change it as it just wasn't happening, it's interesting that you mentioned that vinyl lip because I was wondering if you could use her without any inserts at all, a bit like the cheap inflata-babes (is that what she looks like without an insert?) anyway now you've mentioned that lip I have my doubts, it sounds like it might be painful.

User avatar
erf72
Apprentice
Apprentice
Posts: 19
Joined: Mon Sep 19, 2016 1:55 pm
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by erf72 »

yorktown wrote:8) Howdy

Before using sharp instruments - :!: on an inflata-babe

See if you can just gently rub the insert - starting at the edge and gently using the rubbing motion to pull off the insert - working around the entire insert -

The two NMC air babes I had {Natalie & Cayenne} purchased a few years ago were done that way - although - they showed signs of coming undone just from normal routine usage - but to get the remainder of the insert off - that's the trick I used

She is just such a fine air babe - do note though - as the insert is used more and more - the better it gets - sure is tight in the beginning - but that does loosen up
Thanks for the advice yorktown, I'll give that technique a try, I have previously read she loosens up after some use but the problem is I can't even get that far :)

User avatar
sam treadwell
Doll Advisor
Doll Advisor
Posts: 811
Joined: Fri Jun 24, 2011 1:59 pm
Location: Anaheim
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by sam treadwell »

erf72 wrote: it's interesting that you mentioned that vinyl lip because I was wondering if you could use her without any inserts at all, a bit like the cheap inflata-babes (is that what she looks like without an insert?) anyway now you've mentioned that lip I have my doubts, it sounds like it might be painful.
I've heard of people actually using these dolls that way erf72, and with good success. It's probably the removal and insertion of the inserts that causes the outer lip to split mostly. Still, it would probably be a good idea to reinforce this area none the less. You might be able to get away with using the VLP Vinyl repair by laying a thick bead around the perimeter of the area in question.

As to whether or not it would be a comfortable experience, I can't say as I've never tried a doll this way. But her orifice would probably be just about right without the insert. Even when I installed an after market insert, I still had to deflate my doll down significantly in order to enter her with ease.

Sam

User avatar
hugemistake
Doll Advisor
Doll Advisor
Posts: 546
Joined: Tue Dec 24, 2013 9:22 am
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by hugemistake »

I am glad to see such a renewed interest in these dolls, as expressed recently in this thread and in other threads recently started. I'd like to share on here the "creepy" photo I entered in this month's photo contest. The caption is "It's OK to grab DOLLS by the pussy!" Anyone interested can vote here: http://www.dollforum.com/forum/viewtopi ... 19&t=77568 by logging into TDF and clicking the box next to the photos you want to vote for.
scary.jpg
It's OK to grab DOLLS by the pussy!

User avatar
hugemistake
Doll Advisor
Doll Advisor
Posts: 546
Joined: Tue Dec 24, 2013 9:22 am
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by hugemistake »

Yorktown posted a great comment on the photo contest that's worth repeating:
yorktown wrote:8) Howdy

Yet another great moment in the Inflatable Doll Union - :thumbs_up:

Is the man in the middle going to make Inflata-Babes - Great Again - :thumbs_up:

Vote cast'd - Go Inflata-Babes Go - :mrgreen:
It's OK to grab DOLLS by the pussy!

User avatar
Mick0x
Active Poster
Active Poster
Posts: 55
Joined: Sun Apr 02, 2017 6:06 am
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by Mick0x »

erf72 wrote:Nothing to artistic, just some early pics to show her face and curves, I need to buy some clothes.
Picture 192.jpg
Picture 195.jpg
Picture 181.jpg
Picture 178.jpg
Picture 165.jpg
Picture 199.jpg
Picture 175.jpg
Picture 174.jpg
Picture 155.jpg
Picture 188.jpg
Your Cayenne is a real beauty!!! Gongrats! You are a lucky guy!

Inflatablefun82
Doll Advisor
Doll Advisor
Posts: 875
Joined: Mon Apr 08, 2013 3:40 am
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by Inflatablefun82 »

I'd like a threesome with Kim I and cayenne

bonestaak
Active Poster
Active Poster
Posts: 79
Joined: Tue Oct 08, 2013 1:35 pm
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by bonestaak »

Mick0x wrote:
erf72 wrote:Nothing to artistic, just some early pics to show her face and curves, I need to buy some clothes.
Picture 192.jpg
Picture 195.jpg
Picture 181.jpg
Picture 178.jpg
Picture 165.jpg
Picture 199.jpg
Picture 175.jpg
Picture 174.jpg
Picture 155.jpg
Picture 188.jpg
Where have all the pictures gone?

HorseyGal
Apprentice
Apprentice
Posts: 10
Joined: Wed Mar 11, 2015 9:09 pm
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by HorseyGal »

Hi,

I was wondering from the people who own a Cayenne how robust is she? As in how much can she take without blowing a seam. Not that I plan on going wild or anything but I am on a tight budget and want something that will last.

Also I plan on repainting her face and make up :)

bonestaak
Active Poster
Active Poster
Posts: 79
Joined: Tue Oct 08, 2013 1:35 pm
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by bonestaak »

HorseyGal wrote:Hi,

I was wondering from the people who own a Cayenne how robust is she? As in how much can she take without blowing a seam. Not that I plan on going wild or anything but I am on a tight budget and want something that will last.

Also I plan on repainting her face and make up :)
Although it was the best blow up doll, it was broken the first time after about 5 time use and the second was broken de second time of use. Im done with blow up dolls, Most inflatables have bad inserts and the few that have a good insert are broken after a few times.

HorseyGal
Apprentice
Apprentice
Posts: 10
Joined: Wed Mar 11, 2015 9:09 pm
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by HorseyGal »

Thank you for your response. Still leaning towards getting one. I suppose I am not fussed about the inserts because I'm a girl. It's just for now they are a cheaper alternative then the silicon variety :)

User avatar
peter2005
Newbie
Newbie
Posts: 2
Joined: Fri Jul 28, 2017 6:33 am
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by peter2005 »

hi, how do you guys clean Cayenne's pussy? It looks like it cannot be removed from the body and I've not find a way how to push thru a long pussy-anus sleeve.

How to pour water into one hole and let it run out through the other?

bonestaak
Active Poster
Active Poster
Posts: 79
Joined: Tue Oct 08, 2013 1:35 pm
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by bonestaak »

I used a plastic stick that once for transport when delivering an insert (bestsexdoll) and around it I wrap a handkerchief then push in the insert, then rewind with a new handkerchief. Still remains working and worked.

User avatar
peter2005
Newbie
Newbie
Posts: 2
Joined: Fri Jul 28, 2017 6:33 am
Contact:

Re: Cayenne Cleur and Kimmi Lovecok side by side comparison

Post by peter2005 »

bonestaak wrote:I used a plastic stick that once for transport when delivering an insert (bestsexdoll) and around it I wrap a handkerchief then push in the insert, then rewind with a new handkerchief. Still remains working and worked.
I wonder how company can make a product which is so difficult to clean and also without instructions.
Any other tips from you guys how you deal with it?

Post Reply

INFORMATIONS