Eyes directing

apn12 · Post by **apn12** » Sun May 21, 2017 9:43 am

Has anybody thinked of tool eyes directing? Surface of eye is very slippery, so it is by finger difficult.
Small plunger perhaps?

Post by **RaDiv** » Sun May 21, 2017 10:03 am

Nerf dart?

Cnyb · Post by **Cnyb** » Sun May 21, 2017 6:44 pm

pencil eraser?

HotDiggityDoll · Post by **HotDiggityDoll** » Sun May 21, 2017 7:18 pm

Pin. Poke into the white parts. Lube the eyes first so they move easy.

samara78 · Post by **samara78** » Sun May 21, 2017 9:32 pm

I powder the inside of the eye socket then insert the eye.

apn12 · Post by **apn12** » Mon May 22, 2017 1:14 pm

Thanks information!
I got idea, it works.
Material:
Greeper grid
Tape
Match

lisabt3 · Post by **lisabt3** » Mon May 22, 2017 1:38 pm

The eraser end of a pencil.

apn12 · Post by **apn12** » Mon May 22, 2017 3:30 pm

My tool is slightly better as eraser end of pencil. I compared them.

Cnyb · Post by **Cnyb** » Mon May 22, 2017 7:46 pm

Yeah i would think it can grip better, looks good

sam treadwell · Post by **sam treadwell** » Mon May 22, 2017 10:06 pm

Back when I still worked in the field of electronics, I would occasionally visit the semiconductor manufacturing facilities. I noticed that the technicians at these places used a pretty neat little suction cup tool to avoid exposing the sensitive chips to electro-static discharge, and thus damaging them.

Probably would work well for this purpose, and not too expensive. It comes with different size suction cups as well.

http://www.dx.com/p/ic-chip-vacuum-pen- ... -diy-72691

Nick · Post by **Nick** » Tue May 23, 2017 12:59 am

I have alittle lube in the eye sockets, I just remove the eyelids, adjust the eyes, Then while holding the eye in position with one finger, I put the eyelids back in, it's worked good for me so far. I had one of her eyes jam in the socket and I had to pry it out with a screw driver, there was a little damage to the eye, but on the back of the eye where I pried, so you'd never see it with her eyes in properly..

I do like that little suction cup tool that Sam posted, that looks really handy

apn12 · Post by **apn12** » Tue May 23, 2017 2:55 am

Suction tool looks good. It could be useful anyway.

apn12 · Post by **apn12** » Tue May 23, 2017 6:56 am

Nick wrote:
"I have alittle lube in the eye sockets, I just remove the eyelids, adjust the eyes, Then while holding the eye in position with one finger, I put the eyelids back in"
I agree, almost.

My method:
I put eye to sockets , try to clean lube from eyes surface.
Install face to place, (eyelids do not stay in face when it is removed).
Directing eyes various method.
Install eyelids, (eyes moves during this operation).
Directing eyes again, especially this stage needs tool.